Publicité
Les langues disponibles
Les langues disponibles
24
Docking station
• Assembly: Connect both parts of the docking station- push the charging
unit onto the floor unit until it locks in place.
• Disassembly: Grab the charging unit and pull it firmly out of the floor
unit.
Stick vacuum cleaner
• Plug the stick vacuum cleaner into the electric brush.
• To remove the electric brush from the device, press and hold the electric
brush release button and pull out the electric brush.
Handheld vacuum cleaner
• Make sure to remove the two-piece crevice brush before inserting the
hand vacuum cleaner back into its compartment.
• To install the handheld vacuum cleaner on the stick vacuum cleaner,
start with plugging the lower part into a slot in the stick vacuum cleaner
EN
and push lightly towards the device. Correct placement is signified by
an audible click.
• To remove the handheld vacuum cleaner from the stick vacuum cleaner,
push the handheld vacuum cleaner release button and pull the device
out of the stick vacuum cleaner.
Accessories
• Insert the two-piece crevice brush into a slot in the lower part of the
handheld vacuum cleaner as shown on the figure.
• To remove the accessory, grab and pull it out of the device.
• Store it attached to the hook on the arm of the stick vacuum cleaner.
1. Make sure the device is turned off.
2. Make sure the docking station is placed on a flat and stable surface,
near the power mains socket and away from heat sources, direct
sunlight or wet places.
3. Place the vacuum cleaner on the docking station in such way that
the charging pins on the vacuum cleaner align with the pins on the
charging unit.
4. Connect one end of the AC charger to the charging socket of the
docking station; connect the other end into power supply socket.
ASSEMBLY/DISASSEMBLY
CHARGING
Owner's manual
Publicité
