Koenic KIP 2432 Mode D'emploi page 17

Troubleshooting
If there are any problems during operation, please refer to the following table. If problems cannot
be solved as indicated under Solution, please contact your manufacturer.
Problem / error code Possible causes
Buzzing
(every two seconds)
E1
E2
Eb
E4
E5
E7
E8
Noise during operation
Because of the induction technology, following noises can be occurred during operation:
Noise
Humming
Crackling
Fan noise
IM_KIP2432_180613_V04_HR.indb 17
All manuals and user guides at all-guides.com
No or unsuitable pot on the plate • Use suitable pot or pan for
Surface thermistor is open circuit • Contact your service agent.
Surface thermistor is short circuit • Contact your service agent.
Surface thermistor is disabled
IGBT thermistor is open circuit
IGBT thermistor is short circuit
Supply voltage too low
Supply voltage too high
Meaning
Caused by induction and increases when the power is set on higher level.
Caused by vibration of the cookware bottom during heating
The fan protects the product from overheating. The noise increases
simultaneously with the power level. After turning off the product, the fan
will still operate for some minutes to cool down the product.
Solution
cooking
• Contact your service agent.
• Contact your service agent.
• Contact your service agent.
• Use with required supply voltage,
see Technical Data
• Use with required supply voltage,
see Technical Data
English
17
13/6/18 4:26 pm