Oase BioPress UVC 1000 Notice D'emploi page 7

- English -
Maintenance and cleaning (cont.)
Full cleaning
1. Disconnect all hoses by twisting off the union nuts.
2. Open the closing clamps of the filter container.
○ BioPress 1000: Hold the filter container at the hold-
down element and lift off cover including the foam
filter package.
○ BioPress 1600/2400: Lift off cover including foam
filter package.
3. Lift off cover including foam filter package.
4. Place the cover upside down onto a soft, clean surface,
so that the foam filters with the press ring face up.
○ Remove the press ring by undoing the nut from the
pulling rod.
○ To remove the nut, hold the pulling rod using
combination pliers.
Note: Do not pull the pulling rod out of the cover.
5. Pull off the foam filters.
6. Clean under running water by vigorously compressing
and releasing.
○ Clean the container, cover with meshed tube and
press ring under running water.
7. Push on foam filters so that the pulling rod rests in the
recess of the foam filters.
8. Fit the pressing ring with the rod guidance pointing
down, and screw the nut onto the pulling rod.
○ To tighten the nut, hold the pulling rod using
combination pliers.
○ Ensure that the meshed tube fits completely in the
ring diameter.
○ Remove the cover sealing ring from the container
and check for damage; clean or replace, and place
on the top container rim.
9. Press on the cover including the foam filter package,
allow the closing clamps to engage.
○ Perform a quick cleaning (Section: Quick cleaning).
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
BioPress 1600 / 2400 BioPress 1000
7