Kimex 150-2X01W Manuel D'utilisation page 28

Digital Control Panel For
Electric Height Adjustable Desk
Installation Instruction & User Guide
1
Operating Control Panel
M
V
Memory Upward
/Screen Iock
movement
(unl ock ) Downwar d
Timer movement
Note: If the contrai panel is used for the first time, please reset the system be fore any normal ope ration.
Reset the System:
• To reset the system, press and hold the "Up" and "Dawn" buttons simultaneously. The unit emits one beep and the display shows
"IIJ'i " and the desk star! moving downward and to the lowest position. Never release the buttons until the unit emits one beep again.
The desk will move upward a little and the display shows the current desk height. The reset pracess is finished.
Height Adjustment: Press and hold the "UP"/"DOWN" button to lift/lower the desk to your desired height. Press and release the button to
lift/lower the desk precisely.
limer:
• Press the "T" button to set the period of lime to inform users to stand up. Each press of the "T" button leads to an 0.5 hour increment.
The maximal setting of lime is 2 hours. After setting a period of lime, the display will flash for seconds and il will automatically return
to show the height of the desk. Then the indicator light on the top right of panel will be on.
• The unit emits 5 beeps to remind the users when the set lime is up.
• To cancel the limer, repeatedly press the " T " button until the display shows the current height and the indicator light is off.
Memory Setting:
• To store a memory position, press "M" button and the display will flash "Ill". Wh ile the "S-" is displayed, press the button 1, 2 or 3.
• To call a stored position, press memory button 1, 2 or 3 and the system will star! moving to the desired memory position. The display
will count the height as il is driving to the memory position. Press any button to stop the motion.
Screen Locking Function:
• For safety reasons this contrai panel has a locking function. To activate / cancel the locking function, follow the "PART3-Custom
Pragramming Guide: To Change the Screen Lock Function".
• To Iock the contrai, press "M" for 3 seconds. If the contrai is locked, only a bar ... " is lighting in the display and any operation is invalid.
• To unlock the contrai, press "M" for 3 seconds. The height will be shown in the display. The contrai will be active for 1 minute but
when there are no activations made within 1 minute, the contrai will go in to locking mode again with the locking function is on.
Switch between CM and INCH: Keep the "T" button pressed for approximately 3 seconds and the reading will change fram the current setting.
Power-saving Mode: The system will enter into power-saving mode with display becomes dark when no actions for over 10 minutes.
Touch any button to activate the contrai panel.
Control App Operation:
• To connect the desk with the phone, follow the Guidebook of Smart Lite App Installation and Operation.
• To disconnect the desk fram your phone, press the "M", T and "DOWN" buttons simultaneously for 3 seconds, the unit emits one beep.
• To erase all data (factory reset), press the "M", T and "UP" buttons simultaneously for 5 seconds, the unit emits one beep.
Note: this setting is the same with the ''.Erase Ali Content and Settings" function on the contrai App.
• After re-connecting your phone to the desk, there will be a pop-up notification to remind you to set a reminder lime when you first
access the App's Health Page. After you press "Confirm" the desk will star! the limer.
c+--+-11--- l ndicator
light
1 2 3
Memory 1 / 2 / 3 D isplay