Publicité
Les langues disponibles
Les langues disponibles
Assembling the Fixing Plate
• Align the mounting holes on the fixing plate with the screw holes as shown.
• Attach the fixing plate
E
on the center of the crossbar with 2 screws
Note: The arrow on the fixing plate indicates the direction of sliding in the control box. Follow
the direction of the arrow to mount the control box in the next step.
Phillips
Screwdriver
13
S-E
using a Phillips screwdriver.
S-E
E
OR
The fixing plate can be attached to either of
the right side and the left side.
Attaching the Control Box
• Turn over the desk frame with the crossbar facing up.
At least two people are required when turning over the
desk frame. If only one person turns over the desk frame,
CAUTION
serious bodily injuries might occur.
• Connect the cords, control box and motors.
F
J
Note:
• Please make sure the slot on the control box
F
is facing
upward. There is no corresponding relation between the
motor ports and the lifting columns.
• The picture of the controller is for your reference only.
Actual product may vary.
•
Connect the two motor cords to the two ports
marked "M1" and "M2" (one on each side of the
control box).
HS
•
Connect the controller
J
cord to the port
marked "HS".
AC
G
•
Insert the power plug
G
in the port marked "AC".
14
Publicité
