SW-Motech KFT.22.995.65000/B Instructions De Montage page 179

2
Install DUSC lock
2.1 - Open the DUSC (*) latch buckle and position the lock (1) as shown.
 NOTE: DUSC L ONLY: Make sure the locking tab (highlighted in red) is in the
unlocked position (up)! If necessary, the locking tab must be pushed up into the
unlocked position!
2.2 - Push the lock (1) down until it clicks into place.
2.3 - Screw in the lock (1) using the screws (*) supplied with the DUSC and the
torx key (2). Carefully tighten the screws by hand.
 WARNING: Over-tightening the screws may damage the lock casing!
 NOTE: Ensure that the locking mechanism is in working order!
 NOTE: NEVER lubricate the lock cylinder with oil! Only use graphite powder!
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
5
3
1
×
1
2
×
2
3
×
Errors and omissions excepted
Subject to technical and design changes.