Krüger & Matz TT-501 Mode D'emploi page 12

1. Start/stop buttons Tonearm lift
press this button to start or stop the platter.
2. platter
Note: the platter is equipped with a slip mat. This makes it easier to manipulate the record for
scratch performances.
3. 33 rpm speed selection button
4. 45 rpm speed select buttons
5. Headshell
Install cartridge here. During installation, attach the stylus protector to guard the stylus tip
from damage. Attach wires as follows:
• White (L+) Left channel +
• Blue (L -) Left channel –
• Red (R+) Right channel+
• Green (R-) Right channel –
6. Headshell locking nut
Attach the head shell by inserting it into the front end of the tone arm and then turn the locking
nut clockwise.
7. Tone arm
Fully manual tone arm. To start playback, gently place the stylus on the record using head shell
finger support OR use the tone arm lifter.
8. Tone arm stand with lock
Aluminum nut is used to secure the head shell and cartridge assembly to the tone arm tube.
9. Tonearm lift
Controls the up and down action of the tone arm.
10. Counterweight
Adjustment creates the proper downward pressure of the stylus to the record. We have
installed the counterweight at our factory and it should be perfectly adjusted. If this is not the
case, twist it lightly until the tone arm is perfectly balanced.
11. Output L & R
This is the standard analog output (RCA jacks) which can be connected either to phono or line
input on any Dj mixer, depending on the setting of the phono/line selector.
12. USB SOCKET
plug USB device. The USB lead length is limited to 3m.
13. AUX TO pC
Audio input for connection of an ipod, Mp2 player, etc. to a pC.
14. Ground
Ground lug for turntable connection. Always use this connection when using turntables (your
turntable cable should have a grounding wire).
15. power cable
This power cable should be plugged into a wall receptacle AFTER all audio connections have
been made.
16. Dust cover
Close the dust cover when not in use to protect the unit against dust. Open and remove during
use.
17. Adjustments
The unit has already been adjusted at works. However if you need to adjust the rotation speed,
use these controls.
12
Owner's manual