AeroFlow Mini 650 Mode D'emploi page 12

USER MANUAL
AeroFlow® Surface storage heater with FlexiSmart thermostat
Press OK and use the arrow buttons to go to the menu „Configuration".
Confirm with OK.
Programming mode ON/OFF
Use OK to switch the programming mode ON or OFF.
If the "Programs OFF" is activated, the "Programs" menu is not visible. If
this is the case, you can increase or decrease the temperature manually
using the arrow keys in the "Status display" menu (see page 10).
Open window detection
Select „Configuration" and press OK. With the arrow keys you can go to
„Open window detection" and press OK.
Turn on or off the window open detection by pressing the OK button.
When the window open detection is switched on, the AeroFlow
radiator switches off for not more than 16 minutes if an open window
is detected. The next window open detection takes place at the earliest
20 minutes after the expiry of the 16 minutes.
Holiday mode
The AeroFlow heater can be switched into holiday mode. In holiday
®
mode, the program (if active) is disabled for the duration of the ab-
sence. If the heater is in manual mode , the preset manual temperature
is disabled for the duration of the absence. Only make the adjustment
the day before your departure.
Select „Configuration" and press OK. With the arrow keys you can go to
„Holidays" and press OK.
Use the arrow buttons to enter the number of days you are leaving.
The setting can only be made on the day before the start of your holi-
day. Confirm with OK.
Use the arrow buttons to set the hour of the desired time of return.
Confirm with OK. After this, set the minute of the return time and
confirm with OK as well.
The return temperature is the temperature that should begin on your
return.
If program is disabled, *
you can use the arrow keys to set the return temperature. Confirm with
OK. The status display with the suitcase icon and the number of remai-
ning days off will appear.
If program is active
(menu „Configuration" Programs = ON), the return temperature can
not be selected. After reaching the return time the heating plan will
be continued. If no time frame is active (paused heating between two
time frames), the Antifreeze temperature is applied. So the heating plan
continues as programmed.
The absence temperature corresponds to the Antifreeze temperature.
To change the temperature for your absence, press an arrow key in the
status display. The Temperature-overview display appears. Change the
absence temperature with the arrow keys and confirm with OK.
To deactivate the holiday mode set „days out" to „-" (not „0"). During
holiday mode you can change the Antifreeze temperature in the Anti-
freeze menu, but this will not be applied for the current absence.
Set the time
Select „Configuration" and press OK. With the arrow keys you can go to
„Set the time" and press OK.
Select the current weekday and confirm with OK.
Use the arrow buttons to set the current hour. Confirm with OK.
After this, set the current minute and confirm with OK as well.
Language
Use this menu to change the language of your user interface.
Select „Configuration" and press OK. With the arrow keys you can
go to „Language" and press OK.
Use the arrow buttons to select one of the available languages.
Confirm with OK.
Configuration
Open window detection
®
12
Programs ON
Detection OFF
Holidays
Days out
OFF
Return time
09:00
Return temperature
15.0°C
Set the time
Monday
Select day
Set the time
09:00
Language
english
Language
www.thermotec.ag
*