AeroFlow Mini 650 Mode D'emploi page 11

USER MANUAL
AeroFlow® Surface storage heater with FlexiSmart thermostat
In this menu you can see or change your heating times. You don't see
this menu item? Press OK, go to the „Configuration" and change from
„Programs OFF" into Programs ON" by pressing the OK button. Then
go to „Back" with the arrow keay and press OK.
See
Select „Programs" and press OK. With the arrow keys you can go to
„See" and press OK.
Use the arrow keys to select the day of the week for which you would
like to see the heating plan. Confirm with OK.
See the heating plan on the choosen day. Press OK to exit the menu
item display.
In this menu item, you can not make changes in your heating program.
Set heating time
Set a heating plan according to your preferences.
Select „Programs" and press OK. Go with the arrow keys to
„Set heating time" and confirm with OK.
Choose the day of the week. You can select multiple, non-consecutive
days. Navigate with the arrow buttons to the desired days and select
them with OK. Navigate with the arrow buttons to „set frames" and
press OK.
Select the time window for changing or making a new entry using the
arrow keys and confirm with the OK button.
First enter the hour of the „Start time" and confirm with OK, then the
minutes and confirm with OK, and the cursor will skip to the „End time"
input field.
Enter the hour and confirm with OK, then the minutes and confirm with
OK, and the cursor will skip to the „Temperature" input field.
Enter the desired target temperature and confirm with OK.
After entering all desired time frames, the „arrow-down" button must
be pressed again. The „arrow-back" symbol will appear on the display.
Press OK to fully exit the programming mode now.
Smart Start
Select „Programs" and press OK. With the arrow keys you can go to
„Smart Start" and press OK.
Enable or disable Smart Start. When Smart Start is activated, the room
will be heated up at the adjusted start time of the respective time
frame. See also page 6: paragraph „Smart Start (adaptive start control)".
Press OK to activate or deactivate. To exit the menu, press the „arrow-
down"-button and confirm with OK.
Boost
Use the boost function if you want to increase the room temperature
quickly. Enter into the menu with OK and select „Boost" with the arrow
keys. Press OK to activate the boost function. During boost, the open
window detection is deactivated.
The factory setting is 30 minutes. This time begins to count down imme-
diately after starting up. Use the arrow keys to change the active time of
continuous operation of the AeroFlow® heater in 5-minute increments.
You do not need to press any other button.
To interrupt the Boost function, press the OK button.
Programs
See
Set heating time
Smart Start
Boost
30:00
Boost
11
Thursday
Select day
Start End Temp
08:00-16:00 19°C
16:00-00:00 11°C
Monday
Select day
Set frames
08:00-16:00 19°C
16:00-00:00 11°C
Zeitfenster wählen
Start time
Select time
00:00
08:00-16:00 19°C
16:00-00:00 11°C
Zeitfenster wählen
End time
Select time
05:30
08:00-16:00 19°C
16:00-00:00 11°C
Zeitfenster wählen
Temperature
Select time
11.0°C
08:00-16:00 19°C
16:00-00:00 11°C
Zeitfenster wählen
Select time
08:00-16:00 19°C
16:00-00:00 11°C
Smart Start AUS
www.thermotec.ag