Uline METRO H-10296 Mode D'emploi page 4

11. Align holes on S-bracket (F) with pre-drilled holes on
left door (9). Insert two M3 x 12 mm screws (F) and
attach using a Phillips screwdriver or drill.
(See Figure 8)
12. Align holes on lock (F) with pre-drilled holes on right
door (10). Insert two M3.5 x 16 mm screws (J) and
attach using a Phillips head screwdriver or drill.
(See Figure 8)
Figure 8
F
9
13. Using two people, hold door panel in line with side
panel. Attach frame hinge wing (J) to inside of side
panels using four M3.5 x 14 mm screws (J). Repeat
for seven remaining hinges. (See Figure 9)
Figure 9
PAGE 4 OF 12
ASSEMBLY CONTINUED
Unlocked Locked
F
J
10
9
14. Once door panels are attached, hinge may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 10)
Figure 10
Side
Panel
Door Depth
15. Attach one bracket of wall anchor (R) to back of top
of cabinet using two M4 x 20 mm screws. Mark holes
on wall where plastic anchors are to be located.
10
Drill holes using 5/16" drill bit. Mount opposite
bracket of wall anchor to wall with two M4 x 40 mm
screws and two plastic anchors. Tighten cable tie to
prevent tipping. (See Figure 11)
Figure 11
J
Completed
Assembly
1-800-295-5510
uline.com
Side
Door
Panel
Top
Back
Door
Door Angle
Wall
R
0123 IH-10296