Uline METRO H-10296 Mode D'emploi page 2

NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right
to lock.
IMPORTANT: Function of Cam Lock
Make sure the arrow is pointing upward
before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel. To tighten cam lock
pins, grasp lower part of cam lock pin and
tighten using a Phillips screwdriver.
TIGHTENING OF CAM LOCK PINS
NOTE: Use Phillips screwdriver to tighten cam
locks, cam lock pins and screws.
NOTE: Cam lock caps (I) can be applied once
cam locks are tightened for a finished look.
1. Install one cam lock pin (D) in bottom panel (4).
Insert one cam lock (E) into corresponding holes
in skirt panel (6). Fit bottom panel and skirt panel
together and tighten cam locks. (See Figure 1)
Figure 1
D
4
PAGE 2 OF 12
1/4 Right Turn
for Locking
Hold when
tightening
6
E
4
D
E
D
4
ASSEMBLY
2. Insert four cam lock pins (D) and four dowels (G)
into back panel (5). Insert four cam locks (E) into
bottom panel (4) and fixed shelf (7). Attach bottom
panel and fixed shelf and tighten cam locks using a
Phillips head screwdriver. (See Figure 2)
3. Align holes on L-bracket (F) with pre-drilled holes in
fixed shelf (7). Insert two M3 x 12 mm screws (F) and
attach using Phillips head screwdriver. (See Figure 2)
Figure 2
4
4. Insert nine cam lock pins (D) and six dowels (G) into
right side panel (2). Insert nine cam locks (E) into
bottom panel (4), fixed shelf (7), back panel (5) and
skirt panel (6). Attach panels and tighten cam locks
using a Phillips screwdriver. (See Figure 3)
Figure 3
1
1
7
G
G
D
G
4
5
7
G
4
E
D
D
1
F
5
E
D
4
4
6
0123 IH-10296