Uline METRO H-10296 Mode D'emploi page 3

5. Insert nine cam lock pins (D) and six dowels (G)
into left side panel (1). Insert nine cam locks (E) into
bottom panel (4), fixed shelf (7), back panel (5) and
skirt panel (6). Attach panels and tighten cam locks
using a Phillips head screwdriver. (See Figure 4)
6. Insert adjustable glides (A) into bottom of side
panels. (See Figure 4)
Figure 4
4
A
2
7. Align holes on door plug (K) with pre-drilled holes in
top panel (3) and gently tap with a rubber mallet to
insert. Insert six cam lock pins (D) and six dowels (G)
into top panel. Insert six cam locks (E) into back
panel (5), right side panel (2) and left side panel (1).
Attach top panel and tighten cam locks using a
Phillips screwdriver. (See Figure 5)
Figure 5
1
7
4
PAGE 3 OF 12
ASSEMBLY CONTINUED
5
7
2
E
D
D
2
3
5
E G
2
D
2
8. Place cabinet upright. Insert 12 shelf dowels (H)
into side panels. Place shelves (8) inside cabinet
and ensure shelf supports lower onto shelf dowels.
Tighten shelf supports in underside of shelves for a
secure fit. (See Figure 6)
Figure 6
1
1
9. Place left door (9) and right door (10) panels on a
smooth, non-marring surface to prevent scratching.
Align holes in door hinge wing (J) with pre-drilled
holes in door panels. Insert two M4 x 10 mm bolts (J)
and tighten using a Phillips head screwdriver or drill.
Repeat for seven remaining hinges. (See Figure 7)
10. Attach handles (B) to the outside of door panels
using M4 x 22 mm bolts (B) and a Phillips head
screwdriver. (See Figure 7)
Figure 7
J
K
3
3
8
8
2
7
8
L
4
8
9
1
8
H
B
10
0123 IH-10296