Espressions EP6900 Manuel D'instructions page 20

5.6 Wash the removable parts thoroughly
and rinse them under running water. Dry
thoroughly before placing them back on
the housing. If necessary, wash the parts in
lukewarm soapy water.
Do not wash in dishwasher or hot water to
avoid wear and deformation of the parts.
Dry the parts and follow the steps in
'Assembling the Smart Slow Juicer' to
reassemble the device.
Package contents
•
Smart Slow Juicer
• User Manual
• Cleaning brush
• Container for juice
• Container for pulp
•
Pusher
Technical specifications
Model:
Voltage:
Power:
Net weight:
Dimensions (HxWxD):
Rotation speed of press screw:
Maximum continuous operating time:
Interval between each use:
38
All manuals and user guides at all-guides.com
EP6900
230V~ 50/60Hz
150 W
4,4 kg
525 x 221 x 176 mm
50 RPM
15 minutes
5 to 20 minutes
Troubleshooting
Problem Possible cause
•
The device is connected The plug is not fully inserted into the
to the mains but does socket.
nothing when the
•
The overload and damage protection
Start (on/off) button is
system is activated after prolonged use
pressed.
of the unit.
•
The components of the Smart Slow Juicer
are not assembled correctly.
Strange smell • When using a new appliance for the first
at first use. time, an odour may be released.
•
The Smart Slow Juicer Too many ingredients can cause a
no longer works during blockage in the press chamber.
operation.
•
The overload and damage protection
system is activated.
•
The juice contains too The plastic filter may be damaged
much pulp.
•
The plastic filter is not mounted or not
mounted correctly
•
Strong vibrations and The filter or the pressure screw is not
a strange sound occur correctly fitted or is damaged.
during the first use.
•
The motor has been damaged during
transport or by a fall.
•
Juice is leaking between The rubber seals in the pressing chamber
the upper part and the are incorrectly mounted, damaged or
housing. worn.
•
The hopper does not fit The filter or the pressure screw is not
properly on the press correctly mounted.
chamber.
These are the most common problems and solutions. For any other questions, please contact your
local Smart Slow Juicer dealer.
Note: The warranty will be voided if repairs are made to the Smart Slow Juicer and the housing is
opened unless this is done by an authorised Espressions service point.
Solution
•
Plug the power cord securely and
completely into the power outlet.
•
Unplug and let cool for 30 minutes.
Then try again.
•
Reassemble the Smart Slow Juicer
according to the instructions in
'Installing the Smart Slow Juicer' .
• If the smell persists after several uses,
contact your point of purchase.
•
Use the reverse button to remove the
blockage. Add ingredients more slowly
and do not press too hard. Use harder
fruit in combination with softer fruit. Cut
into smaller pieces.
• Unplug and restart the unit after a 30
minute break.
•
Replace the plastic filter
•
Position correctly according to 'Installing
the Smart Slow Juicer' .
•
Fit correctly according to 'Installing the
Smart Slow Juicer' or replace.
•
Please contact the point of sale.
•
Attach the seals correctly or replace
them. The rubber lip should be in the
pulp outlet and the round ring on the
middle part of the press chamber.
Always position in this way before
pressing.
•
Assemble the filter and squeezing screw
correctly according to 'Assembling the
Smart Slow Juicer' so the plastic filter
and squeezing screw are correctly
positioned on the press chamber.
39