Listening To The Sound - Sony SA-VE815ED Mode D'emploi

3
Secure the center speaker to the
stand with the two supplied screws
and washers.
Notes
• Do not remove the supplied speaker grille from
the speaker while attaching the speaker to the
speaker stand.
• Do not touch or press tweeter's cover on the center
of the speaker.
4
Adjust the angle of the speaker
stand.
Loosen the two screws under the base to
adjust the angle. Then tighten them
again afterwards.
15º
25º
The optional speaker
stands
For greater flexibility in the positioning of the
speakers, use the optional WS-FV10 (floor
stand), WS-TV10 (TV stand), or WS-WV10
(wall mount bracket) speaker stand (available
only in certain countries).
WS-FV10 WS-TV10
Screws
WS-WV10

Listening to the sound

Operation panel on the subwoofer
POWER
ON/
STANDBY
ON/STANDBY
indicator
First, turn down the volume on the amplifier.
The volume should be set to minimum before
you begin playing the program source.
1
Turn on the amplifier and select the
program source.
2
Press POWER on the subwoofer.
The ON/STANDBY indicator on the
subwoofer lights up green.
3
Play the program source.
Power turns on and off
automatically
— Auto power on/off function
When the subwoofer is on (i.e, the
ON/STANDBY indicator lights up green)
and there is no signal input for a few minutes,
the ON/STANDBY indicator changes to red
and the subwoofer enters power saving
mode. While in this mode a signal is input to
the subwoofer, the subwoofer automatically
turns on (auto power on/off function).
To turn this feature off, slide the POWER
SAVE switch on the rear panel to OFF.
POWER
SAVE
Note
If you turn down the volume level of the subwoofer
too low, the auto power on/off function may
activate, causing the subwoofer to enter power
saving mode.
LEVEL MODE
MOVIE
MUSIC
MIN MAX
POWER
AUTO
OFF
9 GB