Publicité
Les langues disponibles
Les langues disponibles
R R e e s s i i d d e e n n t t D D a a t t a a P P r r o o g g r r a a m m m m i i n n g g
Up to 250 resident names and telephone numbers can be set. Each resident
entry is assigned a directory number. The directory numbers are the numbers
visitors enter to have the system call residents.
! NOTE: When entering resident names, programming the AD-500 from a
computer is the preferred method. Refer to the "Programming from the
Local keypad" section of these instructions for details on alphanumeric
entry from the keypad.
Changing the Directory Number Length
The factory settings for the directory number length is 3 digits. It can be set to 2,
3, or 4 digits.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press:
3. Enter the directory number length (2, 3, or 4).
4. Press:
5. Exit Programming Mode if all programming is complete.
Adding a Resident
1. If not already in Programming Mode use the local keypad to enter the
master password and access programming.
2. Press:
3. Enter the directory number that will be displayed for the resident.
4. Press:
! NOTE: To add the name using all capital letters, press
the name.
5. Enter the name of the resident to be displayed (up to 16 characters).
6. Press:
7. Enter the resident's telephone number (up to 12 digits).
8. Press:
9. Exit programming Mode if all programming is complete.
Modifying a Resident
Once resident data has been set, it can be modified to change a resident's name
or telephone number.
1. If not already in Programming Mode use the local keypad to enter the
master password and access programming.
2. Press:
3. Enter the resident's directory number.
4. Press:
! NOTE: To modify the name using all capital letters, press
entering the name.
5. Modify the name of the resident to be displayed (up to 16 characters), or
to keep the name press
6. Press:
7. Modify the resident's telephone number (up to 12 digits) or skip to Step 8.
8. Press:
9. Exit programming Mode if all programming is complete.
Deleting a Resident
Residents can be deleted individually.
1. If not already in Programming Mode use the local keypad to enter the
master password and access programming.
2. Press:
3. Enter the resident's directory number.
4. Press:
5. Enter the resident's directory number again.
6. Press:
7. Exit programming Mode if all programming is complete.
All manuals and user guides at all-guides.com
before entering
before
and skip to Step 6.
7
Publicité
