Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
ALWAYS DUCT THE FAN TO THE OUTSIDE THROUGH A WALL OR
ROOF CAP.
SECTION 8
Finishing the Installation
1.
Reinstall the bottom cover removed in Section 1 using the 4 screws to secure it in place.
2.
Reinstall the filters by fitting them into the channel on either side of the hood and
pushing upwards on them until they are secured in place (Figure 11).
Figure 11
3.
Install a 60 watt maximum type A19 bulb and reinstall the lamp cover.
4.
Turn switches to the "OFF" position and restore power. Test that the light and the fan are
operating properly.
5.
If there is any vibration noise, check for the source and try to tighten fasteners or adjust
the tape to make a tighter connection or seal.
SECTION 9
Controls
Your Range Hood is equipped with two rotary switches with one controlling the lighting and the other
controlling the exhaust fan. The light switch has three positions, High ( ● ), Low ( ◗ ), and OFF ( ■ ).
The fan switch is an infinite speed control that can be adjusted to your desired setting. Rotating the
switch counter clockwise until you hear a click will turn the hood off.
Trouble
1. Hood does not operate when the switch is on.
2. Hood is operating, but air moves slower than normal.
3. Hood is making a rattling noise.
Installer:
Place of Purchase:
5084452 Rev. F 11-12
Channel
Troubleshooting Guide
Probable Cause
1a.
A fuse may be blown or a circuit tripped.
1b.
Wiring is not connected properly.
2.
Obstruction in the exhaust ducting.
3a.
Filters are loose.
3b.
Duct connection is loose.
SECTION 10
Maintenance
CAUTION:
SERVICING THE UNIT.
Filters
1.
Grease Filter - Included with your range hood are aluminum grease filters that should be
washed at least once a month. The filters are dishwasher safe and should be washed in a
mild soap or detergent. Reverse the instructions in the "Finishing the Installation" section
of the instructions to remove filters. If the grease filters become damaged, replace with Air
King Model GF-01 Grease Filters.
Charcoal Odor Filter - If you have installed the optional charcoal odor filters, they cannot
2.
be washed and must be discarded and replaced when they become noticeably dirty, have
stopped filtering the odors, or at least once per year. Replace with Air King Model CF-01
Odor Filters.
Cleaning
CAUTION:
AS THEY MAY DAMAGE THE RANGE HOOD.
1.
Clean your range hood with a mild detergent, such as dishwashing liquid, and dry with a soft
cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. Completely dry before
restoring power. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
2.
The fan assembly can be vacuumed when build up (dirt, lint, etc.) accumulates over time.
The fan is permanently lubricated and does not require oiling.
1a.
1b.
2.
3a.
3b.
Installation Date:
Model Number:
www.airkinglimited.com
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE
DO NOT USE GASOLINE, BENZINE, THINNER, HARSH CLEANSERS, ETC.,
Suggested Remedy
Replace fuse or reset circuit breaker.
Turn off power to unit. Check that all wires are connected.
Check for any obstructions in the ducting including filter.
Turn off power to unit. Check that all filter are securely in place.
Turn off power to unit. Check that duct connection is tight.
4 of 12
Publicité
