Publicité
Les langues disponibles
Les langues disponibles
Before You Call For Service...
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Surface units will not
maintain a rolling boil
or cooking is not
fast enough
Surface units do
not work properly
Surface units do not
work.
Surface unit stops
glowing when turned
to a lower setting
Scratches (may appear
as cracks) on cooktop
glass surface
Areas of discoloration
on the cooktop
Plastic melted to
the surface
Pitting (or indentation) Hot sugar mixture spilled
of the cooktop
Frequent cycling
off and on of
surface units
Oven light does
not work
Oven will not work
38
Possible Causes
Improper cookware
being used.
In some areas, the power
(voltage) may be low.
A fuse in your home may be
blown or the circuit breaker
tripped.
Cooktop controls
improperly set.
There has been a main
power supply surge and/or
a power interruption and
surge.
This is normal. The unit
is still on and hot.
Incorrect cleaning
methods being used.
Cookware with rough bottoms • To avoid scratches, use the recommended cleaning
being used or coarse particles
(salt or sand) were between
the cookware and the surface
of the cooktop.
Cookware has been slid
across the cooktop surface.
Food spillovers not cleaned
before next use.
Hot surface on a model
with a light-colored cooktop.
Hot cooktop came into
contact with plastic placed
on the hot cooktop.
on the cooktop.
Improper cookware
being used.
Light bulb is loose.
Plug on range is not completely • Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet.
A fuse in your home may
be blown or the circuit
breaker tripped.
Oven controls improperly set. • See the Using the oven section.
Oven too hot.
What To Do
• Use pans which are flat and match the diameter of
the surface unit selected.
• Cover pan with a lid until desired heat is obtained.
• R
eplace the fuse or reset the circuit breaker.
• Check to see the correct control is set for the surface
unit you are using.
•
On the Control Panel, activate the Self Clean mode
(press the SELF CLEAN button).
•
Wait for 30 seconds and then press the OFF button.
•
The cooktop should now be ready to operate.
• Scratches are not removable. Tiny scratches will become
less visible in time as a result of cleaning.
procedures. Make sure bottoms of cookware are clean
before use, and use cookware with smooth bottoms.
• See the Cleaning the glass cooktop section.
• This is normal. The surface may appear discolored
when it is hot. This is temporary and will disappear
as the glass cools.
• See the Glass surface―potential for permanent damage
section in the Cleaning the glass cooktop section.
• Call a qualified technician for replacement.
• Use only flat cookware to minimize cycling.
• Tighten or replace the bulb.
grounded outlet.
• Replace the fuse or reset the circuit breaker.
• Allow the oven to cool to below locking temperature.
Publicité
