Installation; Setting Up; Battery Charging - Geemarc CL Bluehook Manuel D'utilisation

INSTALLATION

Setting Up

Before you use the CL Bluehook, please take the following two
steps:
1.Charge the battery
2. Pair the CL Bluehook with your mobile phone
(Bluetooth connectivity feature turned on)

Battery Charging

Plug the battery charger into the mains supply and switch the
supply on. Connect the other end of the battery charger into the
charging port on the right hand side of the clip.
During charging a RED LED will be displayed. When charging
is complete, the LED will be turned off.
When using the CL Bluehook for the first time,
charging could take up to three hours. Please wait
until the RED LED is turned off.
7
INSTALLATION
If the RED LED flashes whilst in standby, the CL Bluehook
needs recharging.
Note :
Do not overcharge the CL Bluehook. Once the RED LED is no
longer displayed, remove the charging unit.
Do not use the CL Bluehook whilst it is being charged.
CL Bluehook Pairing
In order to use the CL Bluehook, it must be paired with a mobile
phone.
Pairing is the process of associating Bluetooth devices with
each other. When two devices are paired, they establish a
permanent, secure link with each other. Paired devices remain
paired even when one of the devices is off or the service
connection is stopped/interrupted. Therefore, pairing only
needs to take place once.
8