Publicité
Les langues disponibles
Les langues disponibles
E
E
Important: To ensure that this equipment
reaches
you
in
first
protective coatings have been used. Flush
the equipment through with a suitable
solvent before use.
1.
Attach air hose to connector (19).
Recommended hose size 8 mm bore.
1. Mix coating material to manufacturers
instructions.
2. Turn
needle
adjusting
clockwise to prevent movement.
3. Turn spreader valve (10) counter-
clockwise to fully open.
4. Adjust
inlet
air
r e c o m m e n d e d
Specifications) at the gun inlet with the
gun
triggered.
(pressure
attachment shown under Accessories is
recommended for this).
5. Turn needle adjusting screw counter
clockwise until first thread shows.
6. Test spray. If the finish is too dry reduce
airflow by reducing air inlet pressure or
by the Airflow Valve (22). Screw the
Adjusting Knob in to reduce pressure.
Preventative Maintenance
1.
Turn off air and coating supply and
relieve pressure in the supply lines, or
if using QD system, disconnect from
airline and fluid line.
2.
Remove air cap (1) & (2) and clean. If
any of the holes in the cap are blocked
with coating material use a toothpick to
clean. Never use metal wire which
© 2005 ITW Finishing Systems and Products
All manuals and user guides at all-guides.com
Installation
The hose must be conductive and
class
condition,
electrical bond from the spraygun to
earth should be checked with an
ohmeter. A resistance of less than 10
Ohms is recommended.
2.
Attach fluid supply hose to Fluid Inlet
(28).
Operation
7. If finish is too wet reduce fluid flow by
turning needle screw (18) clockwise or
screw
(18)
reducing
atomisation is too coarse, increase inlet
air pressure. If too fine reduce inlet
pressure.
pressure
(For
8. The pattern size can be reduced by
f i g u r e s
s e e
turning adjusting valve (10) clockwise.
9. Hold gun perpendicular to surface being
gauge
sprayed. Arcing or tilting may result in
uneven coating.
10. The recommended spray distance is
150-200 mm (6"-8").
11. Spray edges first. Overlap each stroke a
minimum of 50%. Move gun at a
constant speed.
12. Always turn off air and fluid supply and
relieve pressure when gun is not in use.
could damage the cap and produce
distorted spray patterns.
3.
Ensure the tip of the nozzle (3) is clean
and free from damage. Build up of
dried paint can distort the spray
pattern.
4.
Lubrication – stud (24), needle (16) and
air valve (13) should be oiled each day.
6
6
the
fluid
pressure.
If
Publicité
