Kucht Professional KMD24S Guide D'installation page 5

ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
Anti-Tip Block Installation Instructions
• To reduce the risk of tipping of the drawer, the Anti-Tip block
must be properly installed located 14-13/16" above the floor
on which the appliance will sit. The 6" Anti-Tip block must
be provided by the installer. See figure 1 and 3. The Anti-Tip
block prevents serious injury that might result from spilled
hot liquids.
• If the Drawer Microwave is ever moved to a different location,
the Anti-Tip block must also be moved and installed. When
installed to the wall, make sure that the screws completely
penetrate the dry wall and are secured in wood or metal so
that the block is totally stable. When fastening, be sure that
the screws do not penetrate electrical wiring or plumbing.
Anti-Tip block
5" (127 mm)
4"
(101.6 mm)
E
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
TINSKB307MRR0_Kucht_24" Drawer KMD24S Install Guide.indd 5 TINSKB307MRR0_Kucht_24" Drawer KMD24S Install Guide.indd 5
6"
(152.4 mm)
3 1/2"
(89 mm)
FIGURE 3
INSTALLATION GUIDE
ELECTRICAL OUTLET
The electrical requirements are a 120 volt 60 Hz, AC only, 15
amp. or more protected electrical supply. It is recommended
that a separate circuit serving only this appliance be provided.
The Drawer Microwave is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded. Should you only have a 2-prong outlet,
have a qualified electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electri-
cal instructions, consult a qualified electrician or service person.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach.
Always check electrical codes for requirements.
Suggested electrical
outlet location*
FIGURE 4
Anti-Tip block
5" (127 mm)
4"
(101.6 mm)
5
10/2/20 11:15 AM 10/2/20 11:15 AM
6"
(152.4 m
3 1/2"
(89 mm