Kucht Professional KMD24S Guide D'installation page 3

UNPACKING YOUR DRAWER
MICROWAVE
• Remove all packing materials from inside the Drawer Mi-
crowave. DO NOT REMOVE THE WAVEGUIDE COVER,
which is located on the top of the appliance.
Waveguide Cover
Oven Cavity
• Remove the feature sticker, if there is one. Check the drawer
for any damage, such as misaligned or bent drawer, damaged
drawer seals and sealing surfaces, broken or loose drawer
guides and dents inside the cavity or on the front side of the
drawer. If there is any damage, do not operate the appliance
and contact your AUTHORIZED SERVICER.
IMPORTANT NOTES TO THE INSTALLER
• Read all of the Installation Manual before installing the Drawer
Microwave.
• Remove all packing material before connecting the electrical
supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
IMPORTANT NOTES TO THE CONSUMER
Keep this manual with your Use and Care Manual for future
reference.
• As when using any microwave oven generating heat, there are
certain safety precautions you should follow. These are listed
in the Use and Care Manual. Read all and follow carefully.
• Be sure your Drawer Microwave Oven is installed and ground-
ed properly by a qualified installer or service technician.
E
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
TINSKB307MRR0_Kucht_24" Drawer KMD24S Install Guide.indd 3 TINSKB307MRR0_Kucht_24" Drawer KMD24S Install Guide.indd 3
Sealing Surface
INSTALLATION GUIDE
CLEARANCES AND DIMENSIONS
• Dimensions that are shown in figure 1 must be used. Given
dimensions provide minimum clearance. Locate electrical
outlet in the shaded area in the upper left-hand corner of the
cutout. See figure 4.
• Contact surface must be solid and level. Pay special attention
to the floor on which the appliance will sit. The floor of the
opening should be constructed of plywood strong enough to
support the weight of the oven (about 100 pounds).
• Check location where the Drawer Microwave will be installed
for proper electrical supply.
• Your appliance can be built into a cabinet or wall by itself or
under a gas or electric wall oven.
• Be sure that the clearance of the floor between the wall oven
and the Drawer Microwave is a minimum of 2".
• The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. The Drawer
Microwave is equipped with a cord having a grounding wire with
a grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances.
WARNING: Improper use of the grounding plug can result in
a risk of electric shock. Do not use an extension cord. If the
power supply cord is too short, have a qualified electrician
or serviceman install an outlet near the appliance.
PERMANENT AND CORRECT INSTALLATION
3-Prong
3-Prong Plug
Receptacle
Ground
Receptacle Box
Grounding Pin
3
10/2/20 11:15 AM 10/2/20 11:15 AM