ETQ TG52T42 Guide D'utilisation page 12

ETQ
EASTERN TOOLS & EQUIPMENT INC
GROUNDING THE GENERATOR
The National Electric Code requires that the
frame of generator and the external electrically
conductive parts of the generator be connected
to an approved earth ground. Local codes may
differ and require other grounding specifications.
For this purpose, please use the ground wire
that attaches from the frame to the generator
unit.
Using a No. 12 AWG (American Wire Gauge)
stranded copper wire to the frame and to an
earth-driven copper or brass grounding rod
provides sufficient safety against shock.
However, local codes may differ. Contact a
local electrician to find out specifications for
grounding your generator.
Note: Grounding your generator is highly
recommended. It helps prevent electrical shock
if a ground fault condition exists in the
generator or in faulty connected electrical
devices. Also, because the generator is rotating
at high speeds, static electricity tends to buildup
within the unit. Grounding helps dissipate the
static electricity buildup often buildup in
underground devices.
Tel: (888)908-6200
OPERATING THE GENERATOR
STARTING THE ENGINE
Before starting the engine, verify that the
engine oil is full, gasoline is full, and air Filter is
in place. Also, disconnect any load from the AC
receptacle, and turn the AC circuit breaker OFF
(Figure 1)
Figure 1. Disconnecting electrical devices
•
Turn the fuel valve to the "On" position
(Figure 2).
· Place the choke lever in the "CHOKE"
position (Figure 3.).
9
Web Site: easterntools.com
Figure 2. Fuel Valve