weinor BiConnect BiSens Agido-3V Mode D'emploi page 12

BiConnect BiSens Agido-3V
Additional information
Deleting the sensor from the receiver
Hold down the UP
keys at the same time for at least 3 seconds 
Transmitter LED flashes briefly.
The receiver will then cease to work using the sensor /
movement keys in the sensor and will need to be re-
programmed if required.
Technical data Agido-3V
Power supply
LR03
Permissible ambient
temperature
Dimensions (L/W/H)
IP code
Radio frequency
Radio protocol
Switching method
Threshold values
Safety notes
For human safety, it is important to follow the safety
notes included with your BiConnect / WeiTronic prod-
ucts.
Please also comply with the following:
Do not interrupt an UP movement triggered by the
-
sensor unless you are absolutely sure that this will
not damage the awning in any way.
Item number 117879-0000
Version 2 2014-09-01
All manuals and user guides at all-guides.com
+ DOWN
Alkaline battery, AAA,
-15 to +50 °C
Only for use in drop pro-
file
Length 130 x width 47 x
height 27 mm
Hole spacing 100 mm
IP 54
868.3 MHz
BiConnect (bidirectional)
WeiTronic (unidirectional)
UP command if
threshold value is
exceeded
1 = very sensitive
(reacts even to gentle
shaking) to
10= barely sensitive (only
reacts to heavy move-
ment in drop profile)
We reserve the right to make technical changes
Page 4/4
The BiSens Agido-3V may be opened to change
-
the batteries. Apart from this, only suitably quali-
fied, authorised persons should carry out any re-
pairs to the sensor.
Keep the controls away from children.
-
Comply with country-specific regulations.
-
General stipulations for radio installations:
Please note that radio installations may not be
-
operated in areas exposed to a high risk of inter-
ference (e.g. hospitals, airports).
The remote control and the sensor may only be
-
used with devices and units which will not pose a
risk to people, animals or objects if the hand
transmitter, sensor or receiver malfunctions, or if
this risk is covered by other safety facilities.
The operator is not protected against interference
-
from other remote signalling equipment and termi-
nals (e.g. radio installations being correctly used
within the same frequency range).
Note:
The BiSens Agido-3V enhances the level of protection
for your high-quality folding arm awning equipped with a
BiConnect radio control.
Please decide at the site of installation whether it is
-
possible to do without a conventional sun/wind or
sun/wind/rain sensor. Please note that, in very
changeable weather, fall (i.e. sharp downward)
winds and gusts cannot always be reliably detected
by all of the available sensors. In these weather
conditions we recommend retracting folding arm
awnings beforehand and switching off the automat-
ic sun control if installed.
Deactivate the BiSens Agido-3V on an awning with
-
manual (crank-operated) Volant Plus if there is a
risk of damage occurring due to the awning retract-
ing automatically while the valance is still open.
Note:
Radio installations transmitting on the same frequency
may disrupt the signal.
Please note that local laws and structural measures
may restrict the permissible range of the radio signal.