Jya Fjord Air Purifie Mode D'emploi page 6

Linking the Device Intelligent Control
to Smartmi Link with Apple HomeKit
1
Open the Home app on your iPhone/iPad.
This product has been linked
2 Tap "Add Accessory" and then scan the HomeKit setup code on the
to the Smartmi Link and can
be controlled using the app.
product sticker (two stickers on the device unit, see illustration), or enter
Scan the QR code or search
the eight-digit setup code above the HomeKit Setup Code. The device
for "Smartmi Link" on the app
will then be linked to the Apple Home app.
store to download and install
the app. Go to the app's
homepage, click "+" in the The device can be linked to Smartmi Link after
linking to HomeKit. Go to the Personal Info
middle of the page, then add
page on Smartmi Link. Tap "HomeKit Info" and
the device as prompted.
then link the HomeKit device as prompted.
Devices linked to Smartmi Link can also be
added to HomeKit. Go to the Device Control
page on Smartmi Link. Tap "Add to HomeKit" in
"Settings" and then link the device to HomeKit
as prompted.
Note: Please ensure that your
Wi-Fi network is both available
and has Internet access.
Place your phone as close to
this product as possible. (This
product does not support 5G
This product will be listed as
"Jya Fjord Air Purifier" in the
app's device listingnetworks)
09
Note:
Please ensure that your Wi-Fi network
is both available and has Internet
access. Place your phone as close to
this product as possible. (This product
does not support 5G networks).
To control this accessory which
is compatible with HomeKit, it is
recommended to use iOS 13.0 or a
later version.
Please keep the HomeKit setup code,
as you will need to scan the code
to link the device to HomeKit after a
factory reset.
iPad and iPhone are trademarks of
Apple Inc., registered in the U.S. and
other countries.
Controlling this HomeKit-enabled
accessory automatically and away
from home requires a HomePod, Apple
TV, or iPad set up as a home hub. It is
recommended that you update to the
latest software and operating system.
HomeKit
Setup Code
Care & Maintenance
Make sure to turn off the air purifier and disconnect power before cleaning.
Cleaning the air purifier
To ensure your purifier works and purifies properly,
use a vacuum cleaner or soft cloth to remove any
dust clinging to Air inlets or housing walls.
Note: It is forbidden to directly rinse or spray the purifier
with water. Do not wipe the purifier with a soaking wet
cloth to prevent water from getting into it.
10
Cleaning the laser particle sensor
Use a non-sharp tool to open the cover of the
laser particle sensor, then use an air blow gun
or hair dryer to clean the sensor and the filter
on the cover, as illustrated in the figure.
Note: Do not use hot air.