RHINO WINCH Co Mode D'emploi page 13

3000lb - 4500lb
Maintenance
Check
Check connections to make sure they are tight.
Replace damaged connectors.
Ensure there is no exposed or damaged wiring,
terminals or cable insulation.
Inspect rope for damage. Replace rope immediately
if damaged.
Keep entire unit free from contaminants. Use a clean
rag or towel to clean.
Check and insert / replace the battery of wireless
remote control.
Turn power off after use.
Troubleshooting
Symptom
Winch will not operate
Runs in only one direction
Will not free spool
No Brake
Winch runs in opposite direction
Motor runs extremely hot
All manuals and user guides at all-guides.com
Before first use After each use Every 90 days
Possible cause
Loose, cut or damaged wiring
The remote battery is critically low
Wireless signal strength is low
Defective remote control
Loose, cut or damaged wiring
Free spool not dis-engaged
Disengaged free spool
Motor leads crossed
Solenoid control crossed
Remote control or trigger switch crossed
Long period of operation
Weight overload
© Rhino Winch Co
√
√
√ √
√
√
√
Check all wiring carefully to ensure good
condition
Replace remote battery or use the wired
remote
Decrease the distance between remote
and winch
Test with the wired remote, replace
wired remotes
Check all wiring carefully to ensure good
condition
Disengaged free spool
Engaged free spool
Reverse electric connections to motor
Reverse black and red wires on solenoid
Reverse electric connections
Stop operation to let the unit cool down
Reduce load
English
√
√
√
√
Remedy
13