DeLOCK 64187 Mode D'emploi page 4

English
Clone Function
Note:
Make sure that the hard drive to which you want to transfer the data has the
same or higher capacity than the hard drive from which you want to copy.
All data which are on the target HDD will be overwritten during the copy
procedure! Therefore we recommend to save the old data before or to use an
empty hard drive.
Clone Function without PC
1. Connect the power supply to the DC jack of the docking station and connect
the power supply to the socket-outlet.
2.
Insert the HDD / SSD from which you want to copy the data into slot HDD1
(Source).
3. Insert the HDD / SSD on which you want to save the data into slot HDD2
(Target).
4. Switch on the Docking Station.
5.
The yellow LED on both slots lights up permanently.
6.
Press the clone button for about 5 sec. in order to activate the clone process.
7. The LED indicates a copy process.
8. The copy process is completed as soon as all LEDs light up blue.
Erase function without PC
1.
Connect the power supply to the DC jack of the docking station and connect
the power supply to the socket-outlet.
2. Insert one or two HDDs / SSDs which you want to erase into the docking
station.
3. Switch on the Docking Station.
4.
The LED on the appropriate slots lights up.
5.
Press the erase button with the help of a ball-point for about 5 sec. in order
to activate the erase process.
6. The yellow LEDs flicker.
7. The blue LED indicates the erase process.
8. The erase process is completed as soon as all LEDs light up blue.
-4-