Suction Function And Heating Of Board; Blowing Function; After Ironing; Maintenance - Siemens TN20 Série Notice D'utilisation

SUCTIoN FUNCTIoN aND HEaTINg
OF BOARD
The suction absorbs the superfluous steam,
which is no longer used after the ironingprocess.
The suction helps hold the garment on the
ironing surface and helps to dry the garment.
Clean ,dry clothes are obtained, ready to be
placed straight in the wardrobe without further
airing. The heated ironing surface stays dry, and
keeps the steam hot so that it passes through
the cover and board to be expelled without
condensing.
Recommendation:
• Through the suction function, light fabrics (silk
etc.) can be held in place on the ironing board,
preventing them from slipping.
• The suction function cools the fabric and fixes
the results of the ironing, guaranteeing. perfect
folds

BLOWING FUNCTION

The blowing allows you to iron without downward
pressure on a cushion of air. This makes ironing
of delicate items, or difficult areas (trousers folds,
pockets, seams, difficult areas to reach), much
easier and avoids the false ceases that seam
crushing can produce.
• For continuous suction function set the selector
switch on position "I".
• For continuous blowing function set the
selector switch on position "II".
• With the switch in position "0" suction and
blowing functions are switched off.
Selector switch
Important: Do not rest the warm iron directly on
the iron storage shelf, always use the iron rest
mat included.

After ironing

• Leave the board on for 10 minutes to dry the
cover and remove any possible condensed
water from the board.
• Turn off the ironing board using the power
on/off switch.
• Remove the plug from the socket.
• Let the equipment cool completely.
• Remove the iron cord support.
• Place the iron on the iron rest pad.
• Unplug the iron/steam generator from the
auxillary socket and remove it from the board.
• Fold the shelf back over the ironing surface.
• Wind the power supply cord on to the cord
winder lugs beneath the board.
• Hold the board leg with your foot to stop it
skidding.
• Operate the height adjustment lever and close
the board.
Note: do not entangle the power cord.
• Store the closed board in a vertical position
with the folded shelf end towards the floor.
• Always ensure that the board does not skid
and tilt. Store the equipment in a dry place and
out of reach of the children.

Maintenance

Changing the cover
For safety reasons (heated board surface) and to
guarantee a perfect operation of the product we
recommend that you use only Siemens ironing
board covers.
Metalised heat reflective covers and covers with
thick lining are not suitable for this equipment
and may cause overheating of the suction
motor.
Original covers and other accessories are
available from authorised technical service
centres.
Model
TN20350
TN24000
Warning:
In case of failure, of faulty equipment or if
damage due to falling over is suspected,
immediately remove the plug from the socket.
Repairs should be exclusively per-formed at
the authorised Service Centre. Repairs
performed by unskilled personnel may cause
serious dangers for users. Responsibility is
declined for damages caused by repairs
performed by unskilled personnel. In these
cases the warranty right is also cancelled.
Accessory code
(After-sales)
00576007
00576680
13
SIEM ENS