Publicité
Les langues disponibles
Les langues disponibles
To view further information
Each time you press INFO button, the next set of information is displayed, cycling through: DLS text, DL
Plus information (this is only displayed if broadcast by the station), signal strength, programme type,
ensemble name, channel number/frequency, signal error rate, bit rate, codec/DAB variant, time and date.
Note: DL Plus presents additional information that can be broadcast by stations and stored temporarily
on your radio.
Dynamic range compression (DRC)
This function reduces the difference between the loudest and quietest audio being broadcast. Effectively,
this makes quiet sounds comparatively louder, and loud sounds comparatively quieter.
Note: DRC only works if it is enabled by the broadcaster for a specific station.
To change the DRC setting, Select Menu > DRC, then press ENTER button to enter the DRC submenu.
Press ">" or "<" to select the available options: DRC off, high, low.
FM radio mode receives analogue radio from the FM band (87.5-108MHz) and display RDS (Radio Data
System) information about the station.
•
Fully extend the telescopic antenna.
•
Rotate the FUNCTION Selector to FM position to enter FM mode.
• Press and hold the "<"/ ">" button to search the station, it will then stop automatically at the first
station it finds.
• Short press "<" or ">" button to tune the radio down or up in 50KHz steps for fine tuning.
•
If the reception is too weak and there is noise on the received station, try to improve the reception
by changing the position of the telescopic antenna.
Station presets
The unit allows you to store up to 20 FM stations which work in the same way as described in DAB mode.
Aux In mode plays audio from an external source such as an MP3 player.
•
Plug one end of the 3.5mm audio cable (included) into the headphone or line out jack on your
player, plug the other end of cable into the unit AUX-IN jack on the back of the unit.
•
Turn on the external audio source and play your device.
•
Rotate the FUNCTION Selector to AUX position to enter AUX-IN mode.
•
The volume level can now be controlled through the main unit. Operate all other functions on the
external device as usual.
Logging on devices (Pairing)
Before using your speaker with a compatible device, such as a mobile phone, for the first time, you must
pair and connect it to the device.
•
Ensure that the Bluetooth function is activated in your player (e.g. mobile phone). For this, refer
to the operation manual of your player.
FM Mode
AUX-IN Mode
Bluetooth Mode
16
Publicité
