Philips HR1858 Mode D'emploi page 7

Electromagnetic fi elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic fi elds (EMF). If handled
properly and in accordance with the instructions in this instruction manual, the appliance is safe to
use according to scientifi c evidence available today.
Preparing for use
1 Wash all detachable parts (see chapter 'Cleaning').
2 Put the plug in the wall socket.
3 Place the juice collector into the appliance (1) and place the pulp container into the appliance
by tilting it forwards slightly (2). Insert the top end fi rst and then push home the bottom end.
(Fig. 2)
While you are preparing juice, you can empty the pulp container by switching the appliance off and
carefully removing the pulp container.
Note: Reassemble the empty pulp container before you continue juicing.
4 Put the fi lter in the juice collector (1) and hold the lid over the fi lter and lower it into
position (2). (Fig. 3)
, Make sure the fi lter is fi tted securely onto the driving shaft ('click').
Always check the fi lter before use. If you detect any cracks or damage, do not use the appliance
and contact the nearest Philips service centre or take the appliance to your dealer.
5 Snap the two clamps onto the lid to lock it into place ('click') (1) and slide the pusher into
the feeding tube by aligning the groove in the pusher with the small protrusion on the inside
of the feeding tube (2). (Fig. 4)
, Make sure the clamps are locked into position on either side of the lid.
6 Place the juice jug under the spout. (Fig. 5)
Place the lid on the juice jug to avoid splattering or if you want to store the juice in the refrigerator.
To separate the foam from the juice when pouring the juice into a glass, insert the foam
,
separator by sliding it into the juice jug. (Fig. 6)
Note: If you want your drink to have a foamy layer, do not use the foam separator!
Using the appliance
The appliance will only function if all parts have been properly assembled and the lid has been
properly locked in place with the clamps.
1 Wash the fruit and/or vegetables and cut them into pieces that fi t into the feeding tube.
(Fig. 7)
2 Make sure the juice jug has been placed under the spout.
3 Switch the appliance on by turning the control knob to setting 1 (low speed ) or 2 (normal
speed). (Fig. 8)
- Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers and raspberries.
- speed 2 is suitable for all kinds of fruits and vegetables.
4 Put the pre-cut pieces in the feeding tube and gently press them down towards the rotating
fi lter by means of the pusher. (Fig. 9)
Do not exert too much pressure on the pusher, as this could affect the quality of the end result and
it could even cause the fi lter to come to a halt.
Never insert your fi ngers or an object into the feeding tube.
All manuals and user guides at all-guides.com
ENGLISH
7