Electrolux ESI64060 Notice D'utilisation page 12

12 electrolux
2. The digital display shows the current
setting for the rinse aid dispenser.
3. Press the start/cancel button to change
the setting. The digital display shows
the new setting.
4. Turn the programme knob to the off po-
sition to save the operation.
SELECT AND START A WASHING PROGRAMME
Do these steps to set and start a washing
programme:
1. Close the door.
2. Turn the programme knob to set the
washing programme. Refer to the chap-
ter 'Washing programmes'.
– The phase indicator light or lights for
the washing programme come on.
– The programme duration in the digital
display flashes.
3. Press the start/cancel button.
– The washing programme starts auto-
matically.
– When the programme starts, only the
indicator light of the phase in pro-
gress stays on. Programme duration
is on with a static light.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
• Press and hold the start/cancel button.
– In the digital display the time duration
of the programme flashes.
All manuals and user guides at all-guides.com
Rinse aid dispenser
deactivated
Rinse aid dispenser
activated
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting
to the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
– One or more phase indicator lights are
on.
The washing programme is cancelled.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with deter-
gent before you set a new washing pro-
gramme.
Setting and starting a washing
programme with delay start
1. Set a washing programme.
2. Press the delay start button until the dis-
play shows the necessary delay start
time for the washing programme. Delay
start time flashes in the digital display.
3. Press the start/cancel button.
– The countdown of the delay start
starts.
– The phase indicator lights of the
washing programme go off.
– In the digital display the delay start
time is on with a static light.
When the countdown is completed, the
washing programme automatically starts
The phase indicator light of the phase in
progress comes on.
Do not open the door during the count-
down to prevent interruption of the
countdown. When you close the door
again, the countdown continues from
the point of interruption.
Cancelling a delay start
1. Press and hold the start/cancel button.
– The phase indicator lights or light
come on.