Publicité
Les langues disponibles
Les langues disponibles
350-30010 350-20011
350-20010 390-20010
3.4. Cabling
Min. ±0,5mm diameter for a distance of 200m
4. OPERATION AND USE
General
- After connection to the power supply, the motion sensors are
ready for use after 1-2min (warm-up time). You can set the degree
of sensitivity by means of the setting screw (fig.11). The fabric
settings are suitable for use of the motion sensor under normal
circumstances. If the motion sensor has a degree of sensitivity
that is either too high or too low, you can optimize the detection
by means of the setting screw.
- You can test the detection zones by means of the built-in walk
test (fig.12).
Note: Test one motion sensor at a time. In test position B, the LED
lights every time the sensor detects motion. After the walk test is
finished, set the jumper to position A.
28
EN
Publicité
