Publicité
Les langues disponibles
Les langues disponibles
Smtlili bretkdowna tnd remediea
YOU NOTICE THAT ...
A luminous display appears when the
unit is switched on.
During commissioning, your system
switches off.
Ventilation continues a few minutes
after your unit is turned off.
The device does not work. The
indicator lights on the keypad remain
off.
An "F-" indication is present on
the product display.
The unit does not work, an error
message "Fx" or "Hx" is shown on the
display and the power is stopped.
The unit emits an odor during the first
few firings.
In the event of bretktge, crtcking or crtcka, even aliight onea, in the glitaa-certmic glitaa,
Regulitr clietning of tir filitera
The air filters located on the front of the furniture should be cleaned regularly with soapy water, depen-
ding on the level of air pollution inside the kitchen. The cleaning period can range from every 2 weeks
to every 2 months.
Once the filters have been cleaned, they must be put back in place completely dry before any new use.
The air filters protect all components inside the cabinet from dust and grease. They are essential for
filtering the fresh air needed to cool all the components and electronic boards that operate the cabinet.
There are 10 square air filters that are positioned and accessible on a front plate inside the cabinet.
These filters filter the fresh air for the 4 electronic generators.
There are 2 air filters of rectangular shape which are present and accessible on the high front part, just
above the control panels. These filter the fresh air for the 16 inductors.
Normal functioning
The connection of your device is
faulty.
Cooling of the electronics.
The unit is not powered. The power
supply or connection is defective.
There is a permanently activated key
on the control keypad
The electronic circuits work
badly.
New device.
Unpliug the unit immeditteliy tnd conttct Cuatomer Service.
POSSIBLE CAUSES
WHAT TO DO?
NOTHING: It is normal.
Check your connection or the
conformity of the connection.
It is normal.
Inspect fuses and circuit breaker
of your electrical installation.
If the defect does not disappear, do
call the After-Sales Service.
Unplug and then plug the product
back in if the problem persists.
Call the After-Sales Service
Department.
Operate the unit for 1/2 hour without
load.
42
Publicité
