Publicité
Les langues disponibles
Les langues disponibles
4-
Press the SELECTION key for the zone you want to adjust, then press the [P / T] key and then use the encoder to select
the desired temperature. By default the setting of a zone is made in power.
The P or T ° led indicates the current setting mode: P for power and T for temperature.
5-
Set each zone in a configuration you wish to memorize. Press the [M] key for 3 seconds until the 3 LEDs flash.
Then select with the encoder the desired memory program (1 or 2 or 3). Then, without any action on your part for 3
6-
Press the memory button [M] briefly and select with the incremental encoder one of the 3stored programs (1or2or3).
Then, without any action on your part for 3 seconds, the settings of the stored program will be sent.
Switch to tempertture aetting:
Stve t configurttion in memory:
seconds the new configuration will be memorized.
Ctlili t atored configurttion:
EN
36
Publicité
