ExecutiveSafe CS-3B Manuel D'utilisation page 6

Programming the Safe
❖
For your safety, please program the Administrative Password and at least one
finger before start using the safe.
❖
The safe is shipped with a preset Administrative Password: 123456 and opening
with anybody's finger.
❖
The safe is shipped with the preprogrammed setting to be opened either with the
fingerprint or the combination (common mode).
❖
To Restore the above factory settings of the safe, press and hold the red push
button located at the back of the door for more than 5 seconds up until a long
beep is heart, or "The factory settings were restored" is announced. See Fig. 4.
❖
The Safe is equipped with an Interactive Voice Response, here after called IVR
please follow it.
Set up Mode
For the safe to be programmed, it is required to enter the set-up mode.
With the door open, press and release the red push button located at the back of the door and
follow the instructions given by interactive voice response. The safe is now in the set-up mode.
See Fig. 3. Enter the Administrative Password (the safe is shipped with an Administrative
password "123456") followed by the "#" button.
Note: If a mistake is made during the entering of the Administrative Password the "*" button can
be pressed to clear the code entered.
Fig. 4