Display - Tenovis Integral D3 mobile Guide Utilisateur

Integral 33 / CS I55 – Integral 1/3/5

Display

Texts and symbols in the display assist you in operating the handset. They
will guide you through the menus and give you information on the status of
your handset.
The functions of the right and left softkeys change according to the current
status. The respective functions are shown in the display directly above the
softkeys.
The lines in the display
Mauer
7442
Clrdown Menu
Symbol denotations
Battery full
empty, (Battery symbol flashing) Capacity for less than five minutes!
When you first load a new battery, the handset does not "know" its
charging status. So no battery signal is shown. The display will only appear
when it is charged in the handset.
Mute: The microphone is off. Your call partner cannot hear you.
No calling signal: Calling signal is set to mute.
Lock: The handset is locked.
Handset: The handset has a telephone connection.
Dual-tone multifrequency dialling: Each push of the button is trans-
mitted to the connection subscriber as a DTMF tone, with audible output
(DTMF post dialling).(The symbol is only visible on Integral 1/3/5 systems)
Headset: You are telephoning using the headset. The housing micro-
phone and loudspeaker are switched off automatically.
Special function activated: Star key was pressed for a long time.
Loudspeaker: The loudspeaker for handsfree operation on the rear
side of the housing is switched on.
Within range of the system: Your handset is within range of a base
station. You can make and receive telephone calls.
Connection to system: Your handset has a radio link.
6
Symbol line indicating the status of the telephone.
Two text lines e.g. for the name and call number.
Function of the right softkey e.g. Menu.
Function of the left softkey, e.g. Cleardown.
Battery nearly full Battery nearly empty Battery