Axis Communications P5512-E Instructions D'installation page 14

AXIS P5512–E PTZ Dome Network Camera
1. Loosen the four top cover screws and remove the top cover.
2. Remove the protective packaging.
1 Protective packaging
3. If replacing the clear/smoked dome cover or installing an SD card, see page 14 and
page 15.
4. Put the top cover back in its original position and fasten two diagonally opposite screws
first (torque < 0.7 Nm), and then the two other screws.
Replace the Dome Cover
Important
This product has a dehumidifying membrane to maintain low humidity levels inside the
dome. To avoid condensation, do not disassemble the camera in rain or in damp conditions.
Note
Be careful not to scratch or damage the dome cover. If possible, keep the protective plastic
on the dome cover until the installation is complete.
Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
See Hardware Overview on page 10 for location of components.
1. Loosen the top cover screws and remove the top cover.
All manuals and user guides at all-guides.com
14
1