SFE 95-STD1 Manuel D'utilisation page 28

S F E
The treated volume is displayed on a running string so as to allow reading a number
greater than 9999.
Press to switch parameters.
The date and time information for the last regenerations carried out are only available if
regenerations have been carried out.
While the statistics are displayed, the regeneration icon is on, if not otherwise indicated.
E
N
4.8 Statistics reset
G
To reset the statistics, move to the first parameter (number of regenerations carried out),
L
press and hold
I flashing CLS for few seconds.
S
H
4.9 Reset eeprom
To reset the eeprom to the default values, proceed as follows. In the service condition
(regeneration cycle not running and clock displayed):
- To open the Statistics menu, press and hold
- Press and release the
- Press and release the
- Press and release the
- Press and hold the
The display shows "rSt" for a few seconds; this means that the eeprom has been reset to
the default values.
NOTE: this procedure does not reset statistical data.
All manuals and user guides at all-guides.com
for 5 seconds; the statistical data are reset and the display shows a
for about 5 seconds
for 5 seconds.
26