LEXIBOOK RCKID Mode D'emploi page 9

RCKID - 06/01 2/08/01 12:06
3) Notes
a) Each time you press the "TV" key, the URC will skip to the next code and transmit a
POWER signal to turn off your TV.
b) If you fail to stop pressing "TV" key right after your TV is turned off, turn on your TV
again immediately. Press "MUTE" key to skip backward and exit the Searching Mode in
time.
c) If two "beep_beep" sounds are heard after pressing the "TV" key, that means you have
already searched for all codes in the library. Press both keys "CH+" and "VOL-" to exit
the Searching Mode and repeat carefully the above procedures to start searching again.
OPERATING THE URC
Once you have set up the URC, it works like your original TV remote controllers. However, certain
function key may not perform depending on the DEVICE CODE searched.
To operate, simply aim the URC at your TV, and then invoke the function. The status indicator will
flash during signal transmission.
TROUBLESHOOTING
Q. My URC does not work at all.
A. Check your TV, if the TV' main switch is turned off, URC could not operate your TV.
A. Check whether batteries are in good condition, inserted properly and is in correct + / -
polarity. See HOW TO LOAD BATTERIES.
SPECIFICATIONS
OPERATING STYSTEM
Preprogrammed infrared remote control system
COMPATIBILITY
Most brands of infrared controlled TVs ( please refer to the Compatible TV Brands List below )
POWER REQUIREMENT
2 x AA batteries
Page 9
All manuals and user guides at all-guides.com