Fein Dustex 25L Mode D'emploi page 28

All manuals and user guides at all-guides.com
OBJ_BUCH-0000000148-003.book Page 28 Tuesday, May 5, 2015 1:22 PM
en
28
The connected load of the power tool
may not exceed the maximum con-
nected load P of the vacuum
A
cleaner's socket outlet.
Please also observe the operating
instructions and safety warnings of
the power tool being connected to the
socket outlet of the vacuum cleaner.
Recommendation: Always operate the
vacuum cleaner via a residual current
device (RCD) with a rated residual
current of 30 mA or less.
The vacuum cleaner may only be
stored indoors.
Operating Instructions.
Operation, see page 10.
Filter replacement and filter cleaning,
see page 11–13/ 30 section "Fault
Finding."
Never vacuum with-
CAUTION
out the flat-fold filter,
as otherwise the motor will be dam-
aged and a health hazard will occur
through increased exposure of fine
dust. When vacuuming fine dust, a
fleece filter bag must be used addi-
tionally.
An adequate ventilation rate L must
be provided for when the outgoing air
is circulated. The circulated airflow
must not exceed 50 % (max.) of the
fresh air volume (room volume x ven-
tilation rate L ). The following applies
w
without special ventilation measures:
-1
L = 1 h .
w
When inserting the fleece filter bag,
pay attention that the closing cover
and the fleece bag face completely
against the interior side of the con-
tainer.
After removing the fleece filter bag,
seal it with the closing cover in order
to avoid debris.
For vacuuming dusts of dust cate-
gory L, only dry flat-fold filters,
which have not been moist or wet,
are permitted to be used.
Before switching from wet to dry
vacuuming, allow the flat-fold fil-
ter to dry or replace through a dry
one. Otherwise, the flat-fold filter will
become unusable.
Keep the flat-fold filter dry and clean
it regularly.
Mount accessories applying only slight
pressure. For disassembling, turn the
parts somewhat against each other
and pull apart.
Switch the vacuum cleaner off before
connecting a power tool to the vac-
uum cleaner's socket outlet. Make
sure that the power tool is switched
off when inserting its plug into the
vacuum cleaner's socket outlet.
After switching off a power tool con-
nected to the vacuum cleaner's socket
outlet, the vacuum cleaner will run on
for approx. 15 seconds and then
automatically switch off.
When wet vacuuming electrically con-
ductive liquids, the vacuum cleaner is
automatically switched off (automatic
shut-off) when reaching the maximum
filling height of the container. Pull the
mains plug from the socket outlet and
empty the container.
When wet vacuuming electrically
non-conductive liquids (e. g., oils,
drilling emulsions), the vacuum
cleaner is not automatically switched
off when reaching the maximum filling
height of the container. Empty the
container in time.