Télécharger Imprimer la page

Lifetime ACTION GRIP 90020 Instructions D'assemblage page 31

Systeme de basket-ball

Publicité

 SECTION 5 (CONTINUED)
TOOLS AND HARDWARE REQUIRED /
5.3
• Attach the handle assembly to the outer tube (ALB)
with the hardware shown. The lock tab (APS) will fi t
into the notch on the outer tube.
• Attachez l'assemblage de la manivelle au tube
externe (ALB) avec les accessoires indiqués. La
languette de verrouillage (APS) s'emboîtera dans
l'encoche dans le tube externe.
• Sujete el ensamble de la manivela al tubo
externo (ALB) usando el herraje indicado. La
lengüeta de cierre (APS) se encajará dentro de la
muesca en el tubo externo.
!
• Make sure the inner channel (AKQ) has been removed from
the outer tube before performing this step.
• Vérifi ez que le Canal interne (AKQ) à été enlevé du tube
externe avant de réaliser cette étape.
• Verifi que que el Canal interno (AKQ) ha sido quitado del tubo
externo antes de realizar este paso.
ACY
ALB
5.5
• Orient the height sticker (AKP) and place it within the grooves of the inner channel (AKQ) as shown. Line up the
bottom end of the sticker with the edge of the inner channel (AKQ), and adhere it to the surface.
• Orientez l'autocollant de hauteur (AKP) et affi chez-la dans les rainures du canal intérieur (AKQ) comme illustré. Alignez
le bord inférieur de l'autocollant avec le bord du canal interne (AKQ), et adhérez-le à la surface.
• Oriente la etiqueta adhesiva de altura (AKP) y péguela entre las ranuras del canal interno (AKQ) como se muestra.
Alinee el extremo inferior del autoadhesivo con el borde del canal interno (AKQ), y adhieralo a la superfi cie.
!
• Wipe any grease that may be on the inner channel before attaching the height sticker.
• Enlevez toute la graisse du canal interne avant d'adhérer l'autocollant de hauteur.
• Quite todo la grasa del canal interno antes de adherir el autoadhesivo de altura.
/ SECTION 5 (SUITE)
OUTILS ET QUINCAILLERIE REQUIS
ACY (x2)
Notch
/ Encoche
/ Muesca
ACY
APS
/ SECCIÓN 5 (CONTINUACIÓN)
/ INSTRUMENTAL Y HERRAJE REQUERIDOS
5.4
• Attach the outer tube bushing (CNJ) to the outer tube
(ALB).
• Attachez la bague du tube externe (CNJ) au tube
externe (ALB).
• Sujete el casquillo del tubo externo (CNJ) al tubo
externo (ALB).
27
ALB
7.5'
AKP
AKQ
CNJ
10'

Publicité

loading