Milnor Mark II Fonctionnement page 14

>_b]Q\ ?`UbQdY_^±=Qb[ 99
DY\d Dg_ GQi GQcXUb 5hdbQSd_b
depending on the optional hardware furnished and the formulas used. The possible methods are as
follows:
Automatically inject chemicals with a pumped chemical or central liquid supply system.
Load the supply injector before starting the cycle. Supplies are flushed in automatically.
Re-load supply injector compartments or manually flush compartment one during the cycle,
when prompted by the formula.
Pour supplies through the soap chute before or during the cycle.
Because the injection method, formulas, and chemicals to be used are determined in the field,
the operator procedures for adding chemicals are determined locally. See the reference manual for
further information on the optional supply injector, liquid supply injection, and formulas.
the Start button ( ).
also sound during the cycle if operator attention is required. Check the display.
41>75B* 3becX 8QjQbTc
CX[cX]V \PRWX]Tb ^][h°CWT \PRWX]T RP] RadbW h^da Q^Sh ^a [X\Qb XU h^d PaT
RPdVWc QTcfTT] cWT cX[cX]V W^dbX]V P]S P bcPcX^]Pah ^QYTRc B^\T \PRWX]Tb cX[c
Pdc^\PcXRP[[h
:TT_ h^dabT[U P]S ^cWTab R[TPa ^U \^eT\T]c PaTPb P]S _PcWb
:TT_ Q^cW WP]Sb ^] cWT R^]ca^[b fWX[T ^_TaPcX]V
3^ ]^c ^_TaPcT cWT \PRWX]T fXcW \P[Ud]RcX^]X]V cf^ WP]S \P]dP[ R^]ca^[b
All manuals and user guides at all-guides.com
Chemical supplies may be added manually or automatically,
When the operator signal is sounding (door closed and formula selected), press
The operator signal will sound when the cycle ends. It may
The cycle is completed.
"TUMBLING"—If desired, open the door, pull the goods down, close the
door, then press the Start button (
"REVERSING" or "DRAIN SPEED"—Press the Signal Cancel button (
to stop cylinder motion and complete the cycle.
=C?E@>>?15 )$##1F % '
) to continue tumbling for two minutes.
)