Publicité
Les langues disponibles
Les langues disponibles
EN
Make sure to turn off the bail lever and remove the battery
pack(s) before performing any maintenance task on your
snow thrower.
1. Remove the 4 sets of nuts and bolts on the middle steel
plate.
2. Remove the 4 sets of nuts and bolts on each side.
3. Remove the impellers (10).
4. Install the new impellers (10).
5. Tigthen the 8 sets of nuts and bolts that you removed.
9.5
REPLACE THE SKID PLATES
17 30 31 19
The range of adjustable height for skid plates is 1.5mm,
when putting the bolts through the U-hole on the skid
plates.
1. Loosen the 2 sets of bolts (17), spacers (31) and nuts (19)
that attach the skid plates (30) to the snow thrower
housing.
2. Remove the skid plates (30).
3. Install the new skid plates (30).
4. Do the same operation on the other side.
9.6
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
WARNING
NOTE
English
10
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The engine is on,
but the impeller
does not turn.
A thin layer of
snow stays behind.
* If you cannot find the solution to these problems, call
1-855-345-3934 .
11
TECHNICAL DATA
Voltage
No load speed
Clearing width
Clearing depth
Impeller size
Weight (without battery
pack)
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery is not
Charge the battery
charged.
by following the
procedures in the
battery and charg-
er manual.
The switch is de-
Have the switch
fective.
replaced by an au-
thorized service
center.
Battery is too cold. Remove battery
from snow throw-
er. Place battery on
charger and allow
to charge for 10
minutes or until
the changing light
turns green. Re-
move from charger
and install in snow
thrower for use.
Battery may re-
Call toll free help-
quire service or re-
line, at
placement.
1-855-345-3934 or
replace battery.
The belt is dam-
Replace the belt.
aged.
The scraper is
Replace the scra-
damaged.
per.
80 V
1800 RPM
22 in (55.9 cm)
13 in (33.0 cm)
18 in (45.7 cm)
25.8 kg (56.9 lbs)
Publicité
