Publicité
Les langues disponibles
Les langues disponibles
> Before Start
> Part Names
in "AV Adjust" - "MCACC" - "Manual EQ Select" (
Front Left
After selecting the speaker frequency from between "63 Hz" and
"16 kHz" with the cursors
frequency between "-12.0 dB" and "+12.0 dB" with / . (Default
Value is "0.0 dB")
0 "63 Hz" can only be selected when this speaker is set to
"Large" in "System Setup" - "Speaker" - "Crossover" (
Front Right
After selecting the speaker frequency from between "63 Hz" and
"16 kHz" with the cursors
frequency between "-12.0 dB" and "+12.0 dB" with / . (Default
Value is "0.0 dB")
0 "63 Hz" can only be selected when this speaker is set to
"Large" in "System Setup" - "Speaker" - "Crossover" (
Subwoofer
After selecting the speaker frequency from between "31 Hz" and
"250 Hz" with the cursors
frequency between "-12.0 dB" and "+12.0 dB" with / . (Default
Value is "0.0 dB")
0 This cannot be selected if "No" is set in "System Setup" -
"Speaker" - "Configuration" - "Subwoofer" (
0 The result may not be as expected depending on the input source and listening mode
setting.
0 If you want to make the adjustments while listening to something, press
controller, and select the Preset you want to adjust in "AV Adjust" - "MCACC" - "Manual
EQ Select" (
P28) first.
40
All manuals and user guides at all-guides.com
> Install
> Initial Setup
P28).
/ , adjust the volume of that
P32).
/ , adjust the volume of that
P32).
/ , adjust the volume of that
P32).
on the remote
> Playback
MCACC Data Check
You can check the number of speaker channels connected and the content and values you
have set for each of the speaker settings.
∫ Speaker Setting
You can check the number of speaker channels connected and the large and small settings
you have set for the low range reproduction capabilities for each of the speakers.
∫ Channel Level
You can check the output level settings for each of the speakers.
∫ Speaker Distance
You can check the distance from each speaker to the listening position.
∫ Acoustic Calibration EQ
You can check the calibration values for the frequency characteristics of each speaker that
were set in "Manual MCACC".
Advanced Setup
| Firmware Update | Others
E
N
Publicité
