Télécharger Imprimer la page

Lifetime POWER LIFT 90228 Instructions D'assemblage page 20

Système de basket-ball
Masquer les pouces Voir aussi pour POWER LIFT 90228:

Publicité

 SECTION 4 (CONTINUED) /
TOOLS AND HARDWARE REQUIRED /
3/4"
(≈19 mm)
(x2)
4.1
• Attach the short extension arms (AKC) to the backboard brackets with the hardware indicated.
• Attachez les bras de rallonge courts (AKC) aux supports du panneau à l'aide de la quincaillerie indiquée.
• Sujete los brazos de extensión cortos (AKC) a los soportes del tablero usando el herraje indicado.
• A centerlock nut requires some effort to
thread onto a bolt. See page 2 for details.
• Un écrou de blocage central exigera
certain effort pour le serrer sur un boulon.
Voir la page 2 pour plus de détails.
• Una tuerca de bloqueo central requerirá un poco de esfuerzo
para enroscarlo en el perno. Ver la página 2 para más detalles.
!
• If necessary, use a bolt to remove any
excess powder coating from the holes in the
backboard brackets.
• Si nécessaire, utilisez un boulon pour enlever
l'excès de couche de peinture en poudre des
trous dans les supports du panneau.
• Si es necesario, utilice un tornillo para sacar el
exceso de recubrimiento en polvo de los huecos
de los soportes de tablero.
SECTION 4 (SUITE)
OUTILS ET QUINCAILLERIE REQUIS
7 5/8" (19.4 cm)
GBU (x1)
DGA (x1)
/
SECCIÓN 4 (CONTINUACIÓN)
/ HERRAMIENTAS Y HERRAJE REQUERIDOS
AKC
AKC
ABN
ABN
AAX
DGA
!
• DO NOT strike this bolt (GBU) with a mallet! If there is diffi culty sliding the bolt into place,
use a wrench to turn the bolt until it has advanced into position.
• NE PAS frapper le boulon (GBU) avec un maillet ! S'il y a diffi culté à faire glisser le boulon
en place, utilisez une clé pour tourner le boulon jusqu'à ce qu'il s'emboîte en place.
• ¡NO golpee el perno (GBU) con un mazo! Si tiene difi cultad deslizando el perno en su lugar,
use una llave para rotar el perno hasta que se encaje en su lugar.
20
ABN (x2)
AAX (x1)
!
• Tighten the centerlock nut (AAX) until it is
fl ush with the end of the bolt.
• Serrez l'écrou de blocage central (AAX) jusqu'à
ce qu'il soit au ras de l'extrémité du boulon.
• Apriete la tuerca de bloqueo central (AAX)
hasta que esté a ras del extremo del perno.
GBU

Publicité

loading