NUK Thermo Express Mode D'emploi page 25

Faults can occur in any electrical device. This does not necessarily mean that the device is defective, so
please check the list to see whether the fault can be eliminated.
Problem
Device not working.
Device is damaged
(e.g. cracks, glass or
power cord defective).
Food not getting hot.
.
Food getting too hot
Power supply:
Power output:
Degree of protection:
Protection class:
7. Help with problems
Reason
There is no power supply. Check whether the plug is in a socket.
The automatic cut-out
(thermostat) is still active.
Excessive temperature
cut-out has responded.
Mechanical action.
Device is switched off.
No water in the bottle
warmer 6.
Too much water in the
bottle warmer 6.
8. Technical data
220-240 V
500 W
I
IPX0
Check the fuses at the fuse box in your home.
Wait 15 min. until the device has cooled down
and can be switched on.
Take the plug out of the socket. Contact the
service address (see "Contact addresses" on
page 111).
Take the plug out of the socket. Contact the
service address (see "Contact addresses" on
page 111).
Switch on the device by briefly pressing the start
button 5 down until the indicator lamp 4 comes
on (see "5.1 Heating baby food" on page 20).
Pour water into the bottle warmer 6 (see
"5.1 Heating baby food" on page 20).
see "5.1 Heating baby food" on page 20.
~
/ 50-60 Hz
23
Remedy
G
B