Publicité
Les langues disponibles
Les langues disponibles
TA ALARM mode: when this mode is selected, any automatic retune mode is not activated.
Only double beep sound(ALARM) is out-put.
When newly tuned station does not have TP information for 5 seconds, beeps come out.
When TP information gets lost at the current station for retune time, the beep sound is out-putted.
When newly tuned station has not RDS signal, PI SEEK is suppressed somewhat
2) PI SOUND/ PI MUTE:
PI SOUND mode: if a car cruises that critical area back and forth, an oscillation phenomenon can be
occurred, because the different PI code can be receive from a same AF. when the different PI sound
(DIP) is heard once in a while, the different PI sound will be heard for less than 1 second.
PI MUTE mode: under above same situation, a mute sound will be heard for less than1second.
3) RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not caught for retune time , the radio start to retune to next same PI station.
When same PI station does not catch 1 cyclic search, the radio goes to last station and waits for 4-5
minutes until PI code is received.
RETUNE L mode: selected as 150 seconds.
RETUNE S mode: selected as 90 seconds.
4) MASK DPI/MASK ALL:
MASK DPI mode: masked only the AF which has different PI.
MASK ALL mode: masked the AF which has different PI and NO RDS signal with high field strength.
5)BEEP ON/BEEP OFF
BEEP ON mode: The beep sound is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled.
6) VOL LAST/VOL DEFA
VOL LAST: When power on the unit, the volume level is equal to the one when the unit was last
switched off.
VOL DEFA: After selecting VOL DEFA, press SEL button to display AVOL, then press VOL+ or VOL-
button to adjust AVOL level.
After ACC-power off and ACC-power on the unit, the volume level is equal to the AVOL
level.
7)CLK ON/OFF
CLK ON: Clock will always show on the display when power off.
CLK OFF: Clock will disappear on the display when power off.
5. POWER ON/OFF & MUTE
When the unit is power off, the unit comes to on by pressing any button except the the RELEASE
button.
When the unit is power on, press and hold the power button for more than 0.5 seconds, the unit goes
into power off mode.
When the unit is power on, press the power to switch the MUTE state on/off.
6. LCD Display
7&8. TUNE, SEEK, TRACK, SKIP UP / DOWN BUTTONS
a) In RADIO mode:
All manuals and user guides at all-guides.com
2
Publicité
