LENCO CS-420 Mode D'emploi page 2

LOCATION AND FUNCTION OF CONTROLS
1. RELEASE BUTTON
Press the REL button to release the front control panel from the unit chassis, then pull it up a little to
remove from the unit chassis.
When the front control panel is removed the LED indicator flashes.
2&3&4. SEL BUTTON (Select) AND VOL+/VOL- BUTTONS
a) Press the SEL button briefly, it is activated as selecting each mode of E. VOL.
-> VOL ->BASS ->TRE -> BAL -> FAD->
When selecting a desired E.VOL mode, press the VOL+ or VOL- button to adjust.
In each mode, the waiting time is about 5 seconds, and the waiting time is over, it returns to the last
display mode .
The mode of E.VOL is operated with following numeric display.
- VOL: MIN(00), 01,......46, MAX(47).
- BASS/TRE: -07, -06,...,00,...+06,+07
- BAL: 0LR9, 1LR9, ..., 9LR9,..., 9LR1, 9LR0
- FAD: 0FR9,1FR9, ..., 9FR9,..., 9FR1, 9FR0
b) Press SEL button and hold for more than 2 seconds to turn on TA SEEK/TA ALARM mode, then press
SEL button shortly and repeatedly to select PI SOUND/PI MUTE, RETUNE L/RETUNE S, MASK
DPI/MASK ALL, BEEP ON/BEEP OFF, USER SET (FLAT/CLASSIC/ROCK/POP),VOL LAST/VOL DEFA ,
STEREO/MONO(in RADIO mode), LOUD OFF/LOUD ON,DX/LOCAL (in RADIO mode), CLK
ON/CLK OFF, CLK 12/24 mode.
After selecting a desired mode, press the VOL- or VOL+ button to select one setup item of the desired
mode.
1) TA SEEK/TA ALARM:
TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio
retunes to next station which has not the same station (PI) as the last station, but has the TP
information.
When TP information gets lost at the current station for retune time which is set by RETUNE
SHORT(90 seconds) or RETUNE LONG(150 seconds), the radio start to retune to next same PI
station. When same PI station does not catch in 1 cyclic search, the radio retunes to next station with
TP information.
All manuals and user guides at all-guides.com
1