D-Link DES-1018P Guide D'installation Rapide page 3

Link/Act/Speed
Green
10/100 Mbps Ports
(Ports 1 to 16)
Off
Green
PoE
(Ports1 to 8)
Red
Off
Installation and Connection
This section describes how to install a
DES-1018P in a standard 19-inch equipment
rack and how to connect cables and power to
the device.
Before You Begin
Observe the following precautions to help
prevent shutdowns, equipment failures, and
injuries:
• Install the DES-1018P in a cool and dry
place. Refer to the Technical Specifications
for the acceptable operating temperature
and humidity ranges.
All manuals and user guides at all-guides.com
When there
is a secure
connection
Solid (or link) to
light 10/100Mbps
Ethernet device
at any of the
ports.
When there is
reception or
Blinking transmission of
data occurring
at 10/100Mbps.
Off No link
The port is
successfully
Solid connected to a
light PoE device and
is powering the
device properly.
The PoE port
has failed,
possibly due to:
1. PoE total
power budget
shortage
2. Over current:
Exceeds the
Solid power current
light of powered
device's
classification.
3. Short circuit:
An intentional
short circuit has
been performed
on a powered
device.
No connection
Off
to a PoE device
• Install the Switch in a site free from strong
electromagnetic source, vibration, dust,
and direct sunlight.
• Leave at least 10 cm of space at the
left and right-hand side of the Switch for
ventilation.
• Visually inspect the power jack and make
sure that it is fully secured to the power
cord.
• Do not stack any device on top of the
Switch.
Step 1 – Unpacking
Open the shipping carton and carefully unpack
its contents. Please consult the following
packing list to make sure that all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for a replacement.
Package Contents
DES-1018P Switch
Power Cord
Power Cord Retainer
Rack Mount Kit and Rubber Feet
Quick Installation Guide
Step 2 – Installation
You can mount the DES-1018P into a
standard 19-inch equipment rack. To install the
DES-1018P into a rack:
1. Attach the mounting brackets to each side
of the chassis as shown in Figure 3 and
secure them with the screws provided.
Figure 3. Mounting Brackets
1
1
1
1
1
3