Publicité
Les langues disponibles
Les langues disponibles
NaviTrack™ Line Transmitter
High Voltage Indicator
Whenever the line transmitter encounters voltage higher
than 30V (RMS) it will flash a red LED at the bottom left
of the keypad.
Chart 1 Troubleshooting
PROBLEM
Receiver will not pick
up the line transmitter's
signal.
Unit will not turn on.
All manuals and user guides at all-guides.com
PROBABLE FAULT LOCATION
Check that the correct frequency is selected.
Make sure that the leads to line and to the ground are attached securely.
Circuit connection has too much resistance impeding current flow.
Check orientation of batteries.
Check that the batteries are charged.
Check to see that the battery contacts are OK.
Unit may have blown a fuse.
Ridge Tool Company
9
Publicité
