DeLorme inReach Guide De Démarrage page 7

Using the inReach as a
Standalone Device
You can use the inReach as a standalone device when
you don't want to use it with an Earthmate PN-60w.
Power
• Press and hold the Power button for three seconds to
turn the inReach on or off.
» When powering on, release the Power button
when the Power LED is solid green. If the
Power LED starts flashing you are in pairing
mode.
» When powering off, release the Power button
when the Power LED flashes green rapidly.
• When power is low, the Power LED flashes red once
every three seconds.
• When there is not enough power to send any
messages or tracking points, the Power LED flashes
red every 1.5 seconds.
4
Tracking
The Tracking button allows you to send your location at
10 minute intervals to explore.delorme.com when you
are using the inReach in standalone mode.
Press and hold the Tracking button for three seconds to
start or stop tracking. The Tracking LED will flash green
once every three seconds until you cancel tracking or
turn off the inReach.
Message
The Message button lets you send predefined mes-
sages that you created on explore.delorme.com when
you are using the inReach in standalone mode.
• To send predefined message one, press and hold the
Message button until the LED flashes once and then
release the button. The Message LED will flash once
every three seconds until the message is sent.
• To send predefined message two, press and hold the
Message button until the Message LED flashes twice
and then release the button. The Message LED will flash
twice every three seconds until the message is sent.
• To send predefined message three, press and hold the
Message button until the Message LED flashes three